An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on cds1500 tape eraser, erasing hard drives, degaussing equipment, and degaussing services, see also: v92 video tape eraser hd-1 degausser data corp wipe drive donate erase hard drive per-4516 eraser mds-4 video tape degausser cleaning hard drive before selling computer how to delete my hard drive how to erase a hard drive windows xe pc hard drive cleaning mds-4 tape degausser cds1500 tape eraser sv91m hard drive eraser what files are safe to delete from my hard drive sv91m hard drive degausser erase ntfs hard drive free how to erase my hard drive v-94 video tape degausser used computers pc hard drive cleaning per-1100 diskette degausser plasmom optical media cleaners surface data corp wipe drive 1200 cd optical nsa approved erase and freespace and harddrive computer degausing clean your hard drive v92 video tape degausser how can you erase data from a cd-r v-860 degausser data security holdings v-94 gsa schedule magnetic degausers per-1100 diskette degausser cds 2500a feed hopper tape degausser mds5 video tape degausser c64 disk erase 1200 cd optical nsa approved clean hard drive for free erase rewritable cd utility

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on cds1500 tape eraser, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: