An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on clean up hard drive file, erasing hard drives, degaussing equipment, and degaussing services, see also: mds5 hard drive degausser hard drive file cleaning software erase harddrive completely hard disk nuke eraser dlt cleaning erase ntfs hard drive free per-4516 degausser wipe hard drive clean software when i reinstall windows 98 does it erase all my files erase harddrive software tv degauss wand how to delete a hard drive erase harddrive completely how magnets erase tape memory how to erase files on hard drive v-94 tape degausser visual basic mshflexgrid erases row data recordset how to erase files on hard drive erase hard drive computer v-890 tape eraser delete hard drive win 98 hard drive clean up reviews hard drive erase utility mssql 2000 cleaning data repeating field separators per-4516 tape degausser mds-4 audio tape eraser mssql 2000 cleaning data repeating field separators per-1100 diskette degausser per-1100 diskette eraser g disk hard drive eraser delete hard drive win 98 erase rw cd disks automatically erase file after reading adt security services data center nashville tennessee visual basic msflexgrid erases row data recordset program clear worksheet data delete erase your harddrive pf252 tape degausser sv91m diskette degausser unix admin and wipe disk and erase all

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on clean up hard drive file, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: