An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on degausing television screen, erasing hard drives, degaussing equipment, and degaussing services, see also: how to erase a hard drive windows xe erasing floppy disk degauss data security acts and laws per-1100 drive eraser make clean room hard disk clean your hard drive dlt cleaning manually cleaning hard drive how to delete my hard drive v-880 tape degausser hard drive file cleaning software navy degausing system product tv degauss wand cannot delete data folders from outlook 2002 freeware erase internet files dlt cleaning cds1500 diskette eraser erasing floppy disk degauss v-860 tape eraser whole-house media air cleaners sv91m disk eraser v-860 tape eraser erase rw cd disks hard drive file cleaning software v-890 video tape eraser mds5 degausser per-1100 hard drive eraser hd-1 professional hard drive degausser cds1500 diskette eraser steps for cleaning data in a data warehouse per-4516 tape degausser per-4516 tape degausser sv91m disk degausser computer degausing hd-1 audio tape eraser hard drive degauser erase hard drive utility hd-1 professional hard drive degausser sv91m degausser visual basic mshflexgrid erases row data recordset

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on degausing television screen, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: