An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on delete all data from hard disk, erasing hard drives, degaussing equipment, and degaussing services, see also: delete data tracker erase reload dell hard drives freeware delete all data windows me cds 2500a feed hopper degausser how to delete a hard drive what will happen if i completely erase my hard drive degaus zenith tv how can you erase data from a cd-r v-880 tape eraser clean hard drive free trial plasmom optical media cleaners surface v92 degausser erase harddrive completely data cleaning service cleaning hard drive before selling computer delete hard drive win 98 v-860 eraser degauser make degausing television screen whole-house media air cleaners erase media from 8mm tape erase your harddrive remove data from harddrive v-890 tape eraser per-1100 hard drive eraser degauss camcorder how to erase files on hard drive hard drive dod wipe cds1500 diskette eraser sv91m diskette degausser c64 disk erase v-890 video tape eraser erase page files pf252 tape eraser per-1100 drive degausser navy degausing system product erase hard drive computer permanantly delete data how to delete a hard drive per-1100 drive eraser

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on delete all data from hard disk, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: