An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on delete data tracker, erasing hard drives, degaussing equipment, and degaussing services, see also: cds1500 disk eraser v-860 video tape eraser hard drive file cleaning software hard drive erase utility clean gb of memory from hard drive steps for cleaning data in a data warehouse how to erase my hard drive cleaning hard drive before selling computer tv degauser delete hard drive compaq pressario software to erase hard disk data security acts and laws degauss camcorder v-890 video tape degausser degaus zenith tv hd-1 professional hard drive degausser cds 2500a feed hopper tape eraser how to delete win 98sec edition from a hard drive tv degauser healthy climate air cleaner media dlt cleaning used computers mds-4 tape degausser v-94 video tape eraser delete hard drive compaq pressario erase bad credit file hd-1 eraser whole-house media air cleaners v-890 video tape degausser how to delete my hard drive what will happen if i completely erase my hard drive per-1100 hard drive eraser pc hard drive cleaning dlt cleaning cds 2500a feed hopper tape eraser 1200 cd optical nsa approved honeywell f150 media air cleaner steps for cleaning data in a data warehouse clean gb of memory from hard drive sv91m eraser

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on delete data tracker, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: