An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on erase harddrive completely, erasing hard drives, degaussing equipment, and degaussing services, see also: mds5 video tape eraser degauser make cleaning data in a data warehouse erase hard drive mircrosoft erase rw cd disks when i reinstall windows 98 does it erase all my files erase harddrive completely hd-1 degausser sv91m eraser donate erase hard drive wipe hard drive service 1200 cd optical nsa approved mds5 video tape degausser sv91m tape eraser ari degaus manually cleaning hard drive how can you erase data from a cd-r visual basic mshflexgrid erases row data recordset hard disk nuke eraser total erase hard drive clean hard drive for free mds-4 tape degausser how to erase a hard drive windows xe cds1500 disk eraser healthy climate air cleaner media erase rewritable cd utility v-860 tape eraser delete hard drive compaq pressario v-890 tape eraser hd-1 eraser per-4516 degausser v92 hard drive degausser digi tapemaster mds-4 video tape degausser how to delete a hard drive freeware erase internet files v-890 video tape degausser v92 hard drive degausser digi tapemaster hard disk nuke eraser erase reload dell hard drives how to delete a hard drive

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on erase harddrive completely, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: