An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on erase page files, erasing hard drives, degaussing equipment, and degaussing services, see also: mssql 2000 cleaning data repeating field separators mds5 degausser pf252 tape eraser cannot delete data folders from outlook 2002 v-860 gsa schedule erase harddrive completely degauser make td1b tape degausser cds 2500a feed hopper tape degausser scrub secure erase hard disk degauss camcorder 1200 cd eraser delete all data from hard disk mds5 video tape eraser sv91m diskette eraser cleaning out a full hard drive what will happen if i completely erase my hard drive how to delete my hard drive how to erase a hard drive windows xe hd-1 professional hard drive degausser v-880 tape eraser sv91m diskette degausser data security holdings freeware delete all data windows me erase hard drive computer total erase hard drive hd-1 video tape eraser navy degausing system product erase your harddrive total erase hard drive steps for cleaning data in a data warehouse v-890 tape eraser per-4516 tape degausser mds-4 audio tape degausser erase media from 8mm tape erase data cd and microwaves delete all data from hard disk software to erase hard disk dlt cleaning 4000 fs video tape eraser

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on erase page files, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: