An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on hard drive dod wipe, erasing hard drives, degaussing equipment, and degaussing services, see also: cleaning up a hard drive wipe it: the hard drive eraser how to partition and erase a harddrive cds1500 tape eraser sv91m hard drive degausser mds5 eraser hard disk nuke eraser erase your harddrive degauss magnet per-1100 drive degausser v92 degausser degauss magnet how to erase the hard drive hd-1 professional hard drive eraser how to delete win 98sec edition from a hard drive v92 eraser sv91m diskette degausser software to erase hard disk permanantly delete data forums v-860 tape eraser tv degauser hd-1 professional hard drive degausser hd 2000 bulk degausser erase data cd and microwaves per-4516 tape eraser sv91m hard drive degausser cleaning data in a data warehouse visual basic recordset mshflexgrid erases row data program clear worksheet data delete v-94 tape degausser sv91m degausser wipe hard drive service hard drive clean up reviews v-860 tape eraser windows xp delete unnecessary files second hard drive mds5 hard drive eraser program clear worksheet data delete permanantly delete data v-880 degausser mds5 degausser

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on hard drive dod wipe, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: