An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on hd-1 video tape eraser, erasing hard drives, degaussing equipment, and degaussing services, see also: wipe hard drive clean software visual basic msflexgrid erases row data recordset hard drive file cleaning software unix admin and wipe disk and erase all what will happen if i completely erase my hard drive clean your hard drive mds-4 video tape eraser erase rw cd disks sv91m tape eraser cds 2500a feed hopper tape degausser hd-1 video tape degausser program clear worksheet data delete erase your harddrive western digital disk eraser mssql 2000 cleaning data repeating field separators erase hard drive mircrosoft unix admin and wipe disk and erase all steps for cleaning data in a data warehouse erase reload dell hard drives donate erase hard drive sv91m diskette eraser erase rw cd disks per-1100 hard drive eraser magnetic degausers v92 eraser cleaning hard drive before selling computer how to delete all data from hard drive cleaning up a hard drive hard disk nuke eraser steps for cleaning data in a data warehouse erase page files degausing television screen degauss camcorder cds1500 diskette eraser permanantly delete data forums v-860 degausser how magnets erase tape memory program clear worksheet data delete v-94 tape eraser v-860 gsa schedule

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on hd-1 video tape eraser, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: