An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on instructions to erase rewritable cd, erasing hard drives, degaussing equipment, and degaussing services, see also: per-4516 eraser destroy hard drive data delete hard drive win 98 permanantly delete data v-94 gsa schedule what will happen if i completely erase my hard drive program clear worksheet data delete mds-4 audio tape degausser remove data from harddrive erase data cd and microwaves remove data from harddrive v-860 tape degausser 4000 fs video tape eraser data cleaning service erase rewritable cd utility tv degauser clean hard drive for free hd-1 degausser computer degausing western digital disk eraser honeywell f150 media air cleaner c64 disk erase sv91m tape degausser mds-4 video tape degausser mds-4 video tape degausser mds5 hard drive degausser how to delete already deleted items off your hard drive clean hard drive for free per-4516 degausser 1200 cd eraser healthy climate air cleaner media erase hard drive utility mds-4 video tape eraser per-4516 degausser erase hard drive mircrosoft sv91m disk degausser mds-4 tape eraser hd-1 audio tape degausser what will happen if i completely erase my hard drive erase media from 8mm tape

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on instructions to erase rewritable cd, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: