An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on magnetic degausers, erasing hard drives, degaussing equipment, and degaussing services, see also: data security acts and laws v-860 gsa schedule tv degauser mds5 hard drive eraser erase reload dell hard drives per-4516 degausser cds 2500a feed hopper degausser c64 disk erase sv91m hard drive degausser steps for cleaning data in a data warehouse freeware erase internet files installing windows xp on a clean hard drive cannot delete data folders from outlook 2002 v-860 tape degausser hd-1 audio tape degausser v92 eraser western digital disk eraser erase bad credit file delete hard drive compaq pressario tv degauser visual basic msflexgrid erases row data recordset v-860 gsa schedule v-94 video tape degausser delete all data from hard disk steps for cleaning data in a data warehouse erase and freespace and harddrive cleaning up a hard drive erase harddrive software v-890 tape eraser wipe hard drive clean software sv91m diskette eraser cannot delete lexmark network port and data invalid degauser make 1200 cd eraser degaus zenith tv v92 eraser when i reinstall windows 98 does it erase all my files freeware delete all data windows me erase hard drive computer data security acts and laws

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on magnetic degausers, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: