An alternating current (AC) bulk eraser (degausser) is used for complete erasure of data and other signals on magnetic media. Degaussing is a process where magnetic media is exposed to a powerful, alternating magnetic field. Degaussing removes any previously written data, leaving the media in a magnetically randomized (blank) state.

The degausser must subject the media to an alternating magnetic field of sufficient intensity to saturate the media and then by slowly withdrawing or reducing the field, the magnetic media is left in a magnetically neutral state.

To erase recorded data, it is necessary for the strength of the degaussing field to be greater in value than the coercivity of the magnetic media. Simply stated, coercivity is the magnetic field strength, rated in oersteds (Oe), required to change the magnetic orientation of the magnetic material. Check with knowledgeable dealers or degausser manufacturers to identify degausser models that meet your requirements.

Data is typically not lost until its level has been decreased 65% to 75% (or more) below its original saturation recording signal level, dependent upon the drive system.

 

For more information on total erase hard drive, erasing hard drives, degaussing equipment, and degaussing services, see also: hd-1 video tape eraser sv91m hard drive degausser how to delete win 98sec edition from a hard drive per-4516 degausser scrub secure erase hard disk per-1100 disk eraser degausing television screen mssql 2000 cleaning data repeating field separators pf252 tape eraser g disk hard drive eraser cds1500 disk eraser sv91m hard drive eraser cleaning data in a data warehouse mds-4 tape degausser hard drive degauser how to erase the hard drive erase hard drive utility mds-4 audio tape degausser tv degauss wand how to delete a hard drive mac blank cd erase strip mds5 degausser per-4516 degausser hd-1 professional hard drive eraser clean gb of memory from hard drive erasing floppy disk degauss scrub secure erase hard disk permanantly delete data western digital disk eraser data cleaning service per-1100 disk degausser per-1100 disk eraser v-890 video tape eraser per-1100 drive eraser software to erase hard disk tv degauss wand mds5 eraser per-4516 tape degausser permanantly delete data forums hd-1 video tape eraser

A complete erasure level, for most users, is considered to be 60 dB below the original signal level – this of course depends on user requirements. A 60 dB signal decrease equates to reducing the signal to one tenth of one percent of its original value.

Magnetic media products that have factory prerecorded magnetic servo patterns should not be degaussed. Degaussing would erase the factory written magnetic servo signals and leave the media unusable. For all other magnetic media (without magnetic servo signals), after proper degaussing, the quality of subsequent data recording should be unchanged or even improved.

It is very important to understand and follow the degausser’s operating instructions. This is especially important for manual units where the operator controls the media’s movement through the degaussing field. For higher coercivity media, four passes are often recommended – two passes, with a 90 degree rotation for the second pass, and then repeat the process with the media turned upside-down. Of course, these and other important operating considerations will vary with the type, power and construction of the individual degausser models.

For more information on total erase hard drive, degaussers, erasing hard drives, cleaning hard drives, degaussing, and erasing harddrives, see also: